YU Yuphoria YU5010A & YU5010 Frp Unlock Using Fastboot mode 2019 ( 100% Working)

YU5010-A Frp Remove In Fastboot Mode ( 100% Working) 4m433x

Imagine a situation where you have lost your device and someone got their hands on it and without returning it to you, they thought of keeping it to themselves. In this situation, they will wipe the device’s data and settings from Recovery Mode to by the lock screen protection (PIN or Pattern). But to their surprise, they will see a Google page, where you have to use the same Google which was on the device before resetting it. This protection was introduced by Google to prevent thefts and is called Factory Reset Protection (FRP).

YU Yuphoria YU5010 or YU5010A.

Requirement:-

Minimal ADB Tool From Here

Install And Run

And Enter the first command fastboot devices

And Check if Your Device Showing Or Not In Fastboot Mode

And Next Simply Follow the Below Command And Remove Frp Lock

Step 1: Install YU USB Drivers on your PC from here.

Step 2: Also install and set up ADB and Fastboot Drivers on the PC. Make sure to use the 15 Seconds installer and install it system-wide.

Step 3: Boot YU Yuphoria into Fastboot Mode.

Power off the device.
Press and hold the Volume Up and Power buttons together until you see Fastboot Mode on Screen.

Step 4: Connect your device to your PC using a Micro USB Data Cable.

Step 5: Open Command Prompt and enter the below commands:

fastboot –i 0x2A96 erase config

fastboot –i 0x2A96 reboot

Congratulation! Now the Factory Reset Protection or FRP Screen is successfully byed on YU Yuphoria YU5010 or YU5010A.

Disclaimer: This tutorial is for educational purposes only and is not intended for any illegal use. We are not responsible for any misuse of the knowledge shared in this tutorial.